EDUARD [ MORE REVIEWS ] [ WEBSITE ] [ NEW STORIES ]

In-Box Review
172
Consolidated Liberator B.Mk.VI
Consolidated Liberator B. Mk.VI in CBI
  • move

by: Andy Brazier [ BETHEYN ]

history

The Consolidated B-24 Liberator was jokingly referred to by B-17 crews, "as the packing case the B-17 came in", but the Liberator ended World War II as the most produced Allied heavy bomber in history.
The Consolidated B-24 Liberator was not only used by the U.S Air Force but by other nations as well.
The Royal Air Force obtained about 2100 aircraft, with around 1600 of them the H,J and L models, the latter being re-designated as the Liberator Mk VI/VIII. These aircraft were supplied under the lend/lease agreement between the spring of 1944 and August 1945.
the kit

This kit is based on the plastic injection kit of Minicraft's B-24J model, which itself is a pretty good model to start with.
The model comes in the standard Eduard boxing and upon opening the box, its a nice surprise to find everything packed so securely.
The six light grey sprues are bagged in twos, then bagged again all together. The three clear sprues are bagged all together then packed in the main bag.
The rest of the contents contain the A4 size instruction booklet, two sets of Photo Etch, the sheet of decals and a very handy set of masks.
There is very little flash present and ejector pin marks are at a minimum. The plastic does have a little distortion moulded onto it, but nothing that looks to effect the overall model.
The fuselage has a separate nose section, as a lot of the kit is no doubt identical and used as a base kit for the B, H and the PB4Y-1, with a few different sprues added for each version.
The exterior detail is very light engraved panel lines and access panels.
Interior detail is fairly good, but with the inclusion of the P.E parts it really takes it to another level.
The bomb bay has a full bomb load to add if you so wish, and the bomb bay doors can be either modelled open or closed.
Waist gun positions are fully opened, but can be modelled closed, but that is not shown in the instructions. The upper and ball turrets are both movable (like your going to play with it anyway lol).
The clear parts are fairly thick, but nice and clear and devoid of any blemishes. Frames are raised and should help with the positioning of the masks.
The Photo Etched parts

The P.E parts are pretty much for the interior of the aircraft with a lot going into the cockpit and the waist areas.
Seat harness's for two seats in the cockpit along with a arm rests for the seats are included. The bomb aimers stool also gets a set of harness's. There is a new instrument panel along with the control yolks, which do look extremely delicate. P.E for the center console, and the instruments attached to the center of the canopy, complete the now busy looking cockpit section. Most of these are pre-coloured.
The waist areas get a total transformation with a lot of P.E for the side walls. The main facings of these parts are pre-coloured. The two waist guns get a P.E gun-sight added to them, along with P.E ammo belts and boxes.
All four engine facings get a set of wiring harness's added, which will add detail to the quite plain plastic parts.
The aft access hatch is P.E, and comprises a inner and outer skin for the door. This is only shown as modelled in the open postion, but I would imagine it could be closed if you so wished.
The main undercarriage bays have new P.E side walls and a couple of spars for the interior.
The front gear doors have some new actuators to attach, along with new facings.
All the undercarriage legs have brake lines to attach along with a set of P.E oleos.
The Masks

This is not a kit you really want to try and paint the glazing free hand or even mask yourself, so the inclusion of this set is really worth it.
The set covers every piece of glazing on the turrets, canopy, fuselage and lower nose section.
Masks for the wheels are also included.
Instructions

As stated the instructionsis a A4 size glossy booklet.
The first page has a history of the Liberator, along with a brief unit history of each of the aircraft that can be modelled.
The second page is the parts guide. The build starts with the cockpit and follows the usual pattern we are all used to. Each section has blue areas where P.E parts will need to go, and interior colours are given throughout.
A whole page is dedicated to where each mask for the glazing will go. At first it does look confusing, but by working through each section of glazing one by one you will soon figure it out.
The last two pages are the paint and decal guides and are colour profiles of each aircraft.
The instructions don't show whether any weight should be added to the nose. As the aircraft has tricycle undercarriage, I would err on the side of caution and add some weight, where it could be added is another thing altogether mind.
Decals and markings

The decals are printed by Cartograph, and will no doubt be of their usual high quality.
All the decals look to be thin and are glossy in appearance. carrier film is at a minimum.
All four aircraft have nose art, and three of these are of scantily clad women and are well printed, with very minimal carrier film around them.
The four aircraft that can be modelled are -
KH 211, 'Audrey“s Back', No. 99 Squadron RAF ACSEA, Coco Islands, August 1945
KH 283, captain S/L John Gauntlet, No. 159 Squadron RAF ACSEA, 1945
KH 284, 'Donald III', No. 99 Squadron RAF ACSEA, 1945
KH 327, 'Y'vonne Yippee', No. 159 Squadron RAF ACSEA, 1945.
All the aircraft sport a olive drab uppers with neutral grey lowers camo scheme.

Please remember, when contacting retailers or manufacturers, to mention that you saw their products highlighted here - on Aeroscale.
SUMMARY
Highs: A good kit to start with, made even better with the inclusion of P.E and the mask set by Eduard.
Lows: Some of the P.E parts are tiny and very delicate, but that's really just being picky.
Verdict: This is an exceptional kit with enough detailing to give an enjoyable build, without ever becoming to complicated. A very important aircraft that is not often modelled as the more famous and popular B-17 seems to hog all the limelight.
Percentage Rating
85%
  Scale: 1:72
  Mfg. ID: 2110
  Suggested Retail: £30.83
  Related Link: Consolidated Liberator B.Mk.VI
  PUBLISHED: Feb 18, 2011
  NATIONALITY: United Kingdom
NETWORK-WIDE AVERAGE RATINGS
  THIS REVIEWER: 84.81%
  MAKER/PUBLISHER: 88.59%

Our Thanks to Eduard!
This item was provided by them for the purpose of having it reviewed on this KitMaker Network site. If you would like your kit, book, or product reviewed, please contact us.

View Vendor Homepage  |  More Reviews  

About Andy Brazier (betheyn)
FROM: ENGLAND - SOUTH EAST, UNITED KINGDOM

I started modelling in the 70's with my Dad building Airfix aircraft kits. The memory of my Dad and I building and painting a Avro Lancaster on the kitchen table will always be with me. I then found a friend who enjoyed building models, and between us I think we built the entire range of 1/72 Airfi...

Copyright ©2021 text by Andy Brazier [ BETHEYN ]. Images also by copyright holder unless otherwise noted. Opinions expressed are those of the author(s) and not necessarily those of AeroScale. All rights reserved.



Comments

Hi Andy. That looks a stunning kit. The possibilities for further marks looks a good bet with the way Eduard have done the nose. I wonder if it's possible to do the Privateer from it? Nice one Eduard. Thanks for the review Andy. All the best. tim
FEB 18, 2011 - 11:39 AM
The Minicraft B-24J kit which it is based on, has different nose sections, inserts and turret options for the D, H and also a PB4Y-1, which Minicraft already sell. Whether Eduard will continue with this line I don't know, as Eduard have re-boxed the J version as a VI. Andy
FEB 18, 2011 - 11:44 AM
Can't wait to see which assembly ship scheme you choose to do this in!
FEB 18, 2011 - 12:11 PM
   
ADVERTISEMENT


Photos
Click image to enlarge
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
  • move
ADVERTISEMENT